MM101 – D-4E HOT MELT UNIT
69
VALCO MELTON S.L.U. Pol. Ind. Agustinos C/G 34 3116 0 ORCOYEN, NAVARRA
TEL: +34 948 321580 Fax: +34 948 326584 [email protected]
www.valcomelton.com
The system ready signal enables the pump motor. This prevents the pump
motor from being activated before the adhesive in the pump has softened.
Consult the adhesive data sheet to find the softening point temperature of
the adhesive.
The Clock must be On (Clock LED illuminated green) for all of the
programmed scheduled shifts to run, unless the unit will be operated
manually (no pre-programming).
To turn the clock on or off, press the Clock On/Off Button. When the clock
is on, the Clock LED illuminates green. See Section 5 - Setup for detailed
information on setting the clock.
The pump can be set to come on automatically when the unit is ready
(see “Programming Temperatures,” Section 5 - Setup). The pump mode
must beset to Automatic for this to occur (See “Pump Mode,” Section 5 -
Setup). If the pump mode is set to Manual, the Pump On/Off Button turns
the pump on and off . Note that all temperatures must reach the system
ready temperature and the Ready LED must be illuminated for the pump
to operate.
Clock On/Off
Pump On/Off
