ASSEmBLy
FIGURE A
1. Remove your stroller from the carton.
2. Open the frame by, grasping the front bar (1) with one
hand and the handle (2) with the other. Push them
carefully apart until you hear the frame click into place.
3. REAR ASSEMBLY: The “U” shaped tube provides
structural strength and forms the body of the stroller
basket. Insert the “U” shaped end tube over the
open tube ends of the stroller basket. Secure by
simultaneously pressing the two locking buttons on
the underside of the tube, and further inserting the
tubes until they lock into place. Test that the tube is fully
engaged by pulling on it.
FIGURE B
4. With your finger, dab a little petroleum jelly around
each of the 4 wheel housings (3,4) on the stroller frame.
5. Identify both front (3a - round wheel locking rim on
housing) and rear (4a - brake levers on top of the
wheel housing) wheels before use.
6. Insert the rear wheels onto the frame at (4). Be sure
that the brake levers are facing outside, away from
the stroller frame.
7. Insert the front wheels onto the frame at (3). Be sure
that all the wheels click securely into place.
FIGURE C
8. Attach the hood by firmly pressing the clamps on either
side onto the inside of the stroller frame (5).
9. Secure the top of the hood to the frame by wrapping the
elastic around the frame tube and securing with
the snaps. YOUR STROLLER IS NOW READY FOR USE.
OPENING/FOLDING yOUR
STROLLER
FIGURE D
1. Wrap your hand around the folding lock (6).
2. With your thumb, slide the secondary lock across as
far as it will go.
3. Without releasing the secondary lock, squeeze the
primary button (7) - you will feel the frame release.
4. Lift the locking mechanism (8) and ease the frame
slightly forward.
5. While firmly holding the handle, press down on the
plastic tab protruding from the basket. This will cause
the front of the stroller to fold upward toward you.
6. Grasp the front bar, and bring it up to the handle.
7. Secure the stroller closed by sliding the chassis lock (9)
over and onto the locking rivet.
8. To open release the chassis lock and repeat procedures
1 -3. Be sure to check that the chassis is fully locked in
the open position.
A
1
2
B
3
4
C
5
4a
3a
7
6
8
9
D
