desired position. Release the tabs and the
seat will automatically lock in that position
To incline: Place your hand in the centre of
the seat at the rear.
Pull the incline strap (16)desired position.
I>HOOD
Place the plastic hood housings over the
corresponding housing on either side of the
stroller frame (17).
Align the straight track on the stroller housing
with the corresponding channel in the hood
housing. Slide the hood housing downward,
engaging the track fully in the hood channel
so it fully engages onto the stroller frame (18).
The Expanda hood unzips, increasing the
size of your standard hood to give greater
coverage and protection from the sun and
weather for your child.
To open the Expanda Hood:
Locate the zip in the center of the Expanda
Hood and unzip completely (19). Gently pull
the Expanda Hood forward until it is reaches
its full extension.
To close the Expanda Hood:
Gently push the Expanda Hood back, allowing
the middle section to fold in on itself. Carefully
zip the Expanda Hood closed.
IMPORTANT: ALWAYS TAKE CARE WHEN
CLOSING THE EXPANDA HOOD TO AVOID
THE zIPPER CATCHING ON THE ENCLOSED
FABRIC
J>BUMPER BAR
Insert the front bar ends into the nylon
housings located on either side of the frame.
Be sure that the bar is securely engaged(20).
To remove the front bar: Feeling the side of
the nylon housing that sits below the frame at
each side (facing inward), locate the release
button(s). Press each release button inward
while simultaneously pulling upward on the
bar housing. Repeat for the other side. Note
that this may be difficult to do as the bar is
secured firmly as a safety precaution (21).
IMPORTANT WARNING: THE FRONT BAR IS
NEITHER A RESTRAINING NOR CARRYING DEVICE.
K>HANDLE
To lower/raise the handle, simultaneously press
the release buttons on either side of the handle
and move to the desired position (22).
L>HARNESS
Your stroller harness is specifically designed
with many built in safety features.
This includes the requirement that, when
opened, all straps are released so that no
dangerous loops can be formed causing a
strangulation hazard.
WARNING: YOUR CHILD MUST ALWAYS
BE HARNESSED WHEN IN THE STROLLER
Closing your harness: Slide each of the
shoulder strap bottom guides (23) into the
corresponding channel on the top of each
side strap prong.
Insert each completed prong into the central
buckle housing (24).
Carefully adjust the harness straps to snugly
fit your child by adjusting the sliders (25)
located on each strap. The harness should
be fitted to your child’s body, tight enough
so that they cannot wriggle free of the straps
but, loose enough, so as not to cause any
discomfort.
For even more flexibility, the height at which
your shoulder straps are fitted to the stroller
can be adjusted at 3 points. To change the
shoulder strap position:
From the rear of the seat, thread the top of
the strap back through the harness slot (26)
by manoeuvring the locking ring so that it
fits through the slot.
Rethread the strap back through the desired
slot from the front of the seat
Opening your harness:
Press the central housing button (27).
This will release both side prongs from the
central housing. The shoulder and waist
straps will release automatically from each
other.
If the shoulder and waist straps do not
automatically disengage from each other,
