manually slide the guides of the waist
channels. Your harness will separate into 5
sections.
IMPORTANT WARNING: WHEN NOT IN
USE, BE SURE THE SHOULDER AND WAIST
STRAPS ARE ALWAYS DISCONNECTED
FROM THE CENTRAL HOUSING AND EACH
OTHER.
M>FOLDING
Fold the hood up against the handle.
Release the locking clamps at either side
of the stroller (28). Simultaneously lift the
secondary safety catch and swing the
handle forward (29).
Holding the frame at the rear, press down
with your foot on the rear basket tube. This
will disengage the side hinge locks (30).
Continue pushing the rear of the basket,
moving the rear wheels forward beneath the
frame.
You can lock the frame closed by
stretching the locking strap over the
frame, placing the metal catch over
the rivet on the chassis (31).
N>BASSINET ASSEMBLY
Pull back the inner lining and locate the wire
support frames (32).
Lifting the top bassinet frame slightly and
using the finger loop on each support frame,
pull each outward to create the bassinet
body
Be sure to pull each frame as far as it can go
and lock into the stoppers found on the base
of the bassinet (33).
IMPORTANT WARNING: ALWAYS TEST
THAT THE SUPPORT FRAME IS FULLY
LOCKED INTO POSTION
O>REMOVE BUMPER BAR
Remove the front stroller bumper bar by
simultaneously pressing on the tabs, on
both sides, in the bottom of the bar and
lifting it from the frame housing (34) (refer
to point J).
P>INSERT SUPPORT BAR
Insert bassinet support bar into the stroller
frame housing in the same manner as the
bumper bar (35).
Q>ADJUST SUPPORT BAR
Adjust the bar to its lowest position which
will allow the bassinet to be easily inserted
into the pram body (36).
IMPORTANT: BE SURE THAT YOUR
STROLLER SEAT IS FULLY RECLINED.
R>DRESSING
Fold fabrics inside out. Line up each of the
press studs.
Pull the harness through the slits.
Straighten the inner lining in the bassinet
neatly.
Secure by wrapping the end of the lining
over the bassinet sides and end. Straighten
the fabric (37).
S>INSTALLATION
Insert the bassinet into the stroller body as
far as it will go (38).
Simultaneously pressing the buttons at
either side of the bassinet bar, lift it upward
until the bassinet sits level on the strap and
the body is secured in place (39).
To remove the bassinet simply reverse
this procedure, lowering the bassinet
bar and removing the bassinet.
T>CARRYING
Your MATRIX bassinet has been designed
to be easily removed and carried. Test that
the hood is fully extended and locked into
position by pulling it forward as far as it will
go.
To carry the bassinet, grab the padded hood
bar at the top of the hood and away you go!
(40) When the hood is locked in the fully
extended position it has been designed so
that it will not collapse when carried.
WARNING! ALWAYS ENSURE THAT THE
HOOD IS SECURELY LOCKED IN THE FULLY
EXTENDED POSITION BEFORE CARRYING
THE BASSINET
INSTRUCTIONS>BASSINET
