assembly
FIGURE A
1. Lift the handle upward toward you. The frame will
begin to open.
2. Continue opening the frame until you hear it
“click” into the fully locked position.
IMPORTANT: CHECK THAT ALL SEAT STUDS ARE FULLY
ENGAGED BEFORE USE
Install the rear axle/brake bar
FIGURE B
3. With the brake levers (3a) facing AWAY from the
stroller, align the plastic brake housings with the
rear legs (3b). Firmly push each housing onto the
corresponding leg until it locks into place. Test by
pulling on the rear axle.
Insert rear wheels
FIGUre C
4. Depressing the button in the centre hub of the
rear wheel, insert each wheel axle in turn, into
the wheel hub. Push the wheel as far as it will go
before releasing the button.
IMPORTANT: PULL EACH WHEEL SLIGHTLY BACK TOWARDS YOU
TO ENSURE THAT IT HAS FULLY ENGAGED IN THE AXLE.
Insert Front wheels
5. Insert each front swivel wheel over the housing
on the front legs. IMPORTANT: BE SURE THAT THE
SWIVEL LOCK LEVER IN THE HOUSING IS AT THE
TOP.
6. To fix the front wheel in the non swivel position,
turn the wheel so that the two notches on both
housings line up. Press down firmly on the swivel
lock until it locks into place.
to Install the bUmper bar
FIGURE D
7. Align the ends of the bumper bar with the
housing located on either side of the seat.
8. Insert the ends into the housing. Keep pushing
until they lock into place.
This bumper bar is NOT adjustable.
IMPORTANT: NEVER LIFT YOUR STROLLER BY THE BUMPER BAR.THE
FRONT BAR IS NEITHER A RESTRAINING NOR CARRYING DEVICE.
aDJUstInG the Footrest
9. To lower/raise the footrest, simultaneously press
the release buttons and move the footrest to the
desired position.
A
C
D
B
click
click
1
2
3a
3b
7
9
PRESS
4
5
6
7
