Note that the USB cable connection to Insight is only intended for temporary use
during configuration, and must not be used for permanent installations. The IP
rating and EMC properties of the transmitter can be affected when the USB port
is open.
For an overview of using the Insight PC software, see
Insight PC software overview (page 25)
.
2.6 Receiving analog output settings from probe
When you take Indigo201 in use for the first time and have not entered an analog output
configuration, the transmitter automatically adapts the analog output configuration of the first
Vaisala Indigo-compatible probe you connect.
If an analog output configuration already exists in Indigo201 (that is, you have previously
connected a probe or configured the settings), you need to set the analog output
configuration of the new probe manually. Analog output from the transmitter is halted and
does not resume until you have set the new probe's configuration.
Alternatively, you can clear the analog output settings in Indigo201 configuration. This returns
the transmitter to a state where it automatically starts using the analog output configuration
of the next connected probe. For instructions, see
Clearing transmitter analog output
.
Indigo201 User Guide
M212842EN-B
14
