Vaisala AQT530, Configuration Manual

Page: 30 / 64

5. CLI commands and
parameters
5.1 Overview of CLI commands and
parameters
AQT530 CLI commands include the following:
• AQT530 identification commands: motd , uname
• System control command: reboot
• Configuration commands:
date
,
initconf
,
set
,
show
,
write
• Measurement output command:
meas
• LPC identification command:
lpc
• Device status command:
status
The AQT530 parameters include a set of read-only and read/write parameters.
Read/write parameters:
• Modbus interface configuration parameters Table 24 (page 36)
• Temperature unit parameter Table 25 (page 37)
• Linear correction parameters for gases Table 26 (page 37)
• Linear correction parameters for particles Table 27 (page 38)
Read-only parameters:
• Device identification parameters Table 28 (page 38)
• Base module identification parameters Table 29 (page 38)
• Base module monitoring parameters Table 30 (page 39)
• Gas measurement configuration and diagnostics parameters Table 31 (page 39)
• LPC parameters Table 32 (page 39)
• Temperature and humidity probe (TH) probe parameters Table 33 (page 39)
More information
‣
CLI command reference (page 28)
‣
CLI parameters (page 36)
5.2 CLI command reference
The commands are for use in a standard terminal program (command-line interface, CLI).
Table 17 List of commands
Command Description Reference
date [<YYYY-MM-
DDThh:mm:ss>]
Prints or changes current date and
time.
Setting date ( date command)
(page 30)
AQT530 Configuration Guide M212572EN-C
28