1 Safety
4
Installation instructions 0020237057_01
1
Safety
1.1
Intended use
In the event of inappropriate or improper use,
damage to the product and other property
may arise.
The product is intended for using an eBUS
interface to control a heating installation with
heat generators from the same manufacturer.
The radio control, the radio receiver unit and
the wireless outdoor temperature sensor
must be installed in a location that receives
sufficiently high signal. The radio control is
not intended to be portable.
Intended use includes the following:
–
observance of accompanying operating,
installation and servicing instructions for
the product and any other system compon-
ents
–
installing and fitting the product in accord-
ance with the product and system approval
–
compliance with all inspection and main-
tenance conditions listed in the instruc-
tions.
Intended use also covers installation in ac-
cordance with the IP code.
Any other use that is not specified in these in-
structions, or use beyond that specified in this
document shall be considered improper use.
Any direct use in industrial or commercial
processes is also deemed to be improper.
Caution.
Improper use of any kind is prohibited.
1.2
General safety information
1.2.1 Risk caused by inadequate
qualifications
The following work must only be carried out
by competent persons who are sufficiently
qualified to do so:
–
Set-up
–
Dismantling
–
Installation
–
Start-up
–
Inspection and maintenance
–
Repair
–
Decommissioning
▶
Observe all instructions that are included
with the product.
▶
Proceed in accordance with current tech-
nology.
▶
Observe all applicable directives, stand-
ards, laws and other regulations.
1.2.2 Risk of material damage caused by
frost
▶
Do not install the product in rooms prone
to frost.
1.2.3 Danger due to malfunctions
▶
Install the system control in a location
where it is not covered by furniture, cur-
tains, or other objects.
▶
If room temperature modulation is activ-
ated, advise the end user that, in the room
where the system control is mounted, all
the thermostatic radiator valves must be
fully open.
▶
At lengths of 10 m or more, power supply
cables must be laid separately from sensor
or bus lines.
1.2.4 Risk of material damage caused by
using an unsuitable tool
▶
Use the correct tool to tighten or loosen
threaded connections.
1.3
Regulations (directives, laws,
standards)
▶
Observe the national regulations, stand-
ards, guidelines and laws.
