Vaillant sensoCOMFORT VRC 720/3, Operating And Installation Instruction

Page: 12 / 64

12
Operating and installation instructions 0020334316_02
Solar yield Energy yield of the connected solar system
Environmental yield Energy yield of the heat source installation for the connected heat
pumps
Power consumption The installation's electrical energy consumption based on the re-
spective system function and/or the overall installation
Heating Current month , Last month , Current year , Last year , Total
DHW Current month , Last month , Current year , Last year , Total
Cooling Current month , Last month , Current year , Last year , Total
Installation Current month , Last month , Current year , Last year , Total
Fuel consumption The installation's fuel consumption based on the respective system
function and/or the overall installation
Heating Current month , Last month , Current year , Last year , Total
DHW Current month , Last month , Current year , Last year , Total
Installation Current month , Last month , Current year , Last year , Total
Heat recovery Amount of energy saved by the ventilation unit
Burner status: Current burner status of the connected boiler
Air quality sensor 1: Measures the CO
2
content of the room air
Control elements Explanation of the control elements
Menu introduction Explanation of the menu structure
Competent person contact info The competent person can store their telephone number.
Phone number
Company
Serial number Identification of the product. The 7th to 16th digits of the serial
number form the article number
2.14.3 SETTINGS menu item
MENU
SETTINGS
Installer level
Enter access code Access to the installer level, factory setting: 00
If the access code is unknown, reset the system control to the fact-
ory setting.
End external Energy Manager After ending, the system control re-assumes its control function
with its original settings.
Competent person contact info Entering contact details
Service date: Enter the next service date for a connected component, e.g. heat
generator, heat pump, ventilation unit
Fault history Faults are listed in chronological order
Installation configuration
Installation configuration menu item (
→
section 2.14.4)
Sensor/actuator test Selecting a connected functional module and
–
carrying out a function check of the actuators.
–
Carry out a plausibility check of the sensors.
Noise reduction mode Set the time programme in order to reduce the noise level.
Screed drying Activate the Screed drying profile function for freshly laid screed
in accordance with the construction regulations.
The system control regulates the flow temperature independently
of the outdoor temperature.
Set screed drying Installation configuration menu item (
→
section 2.14.4)
Change code Defining an individual access code for the installer level
Language, time, display
Language: Defining the language that is to be shown on the display.
Date: After the power is switched off, the date is retained for approx. 30
minutes.