Set-up 4
0020077989_04 auroTHERM exclusive Installation and maintenance instructions
31
▶
Define the rack clearances. (
→
Page 22)
▶
Transport the required number of weights to the flat roof.
▶
Lay the weights in the final positions of the installation
site.
Note
The four weights for holding two racks for a
collector are extremely heavy. Therefore, it is
advisable to determine the final position and
orientation of the weights before screwing on
the rack and laying the weights there.
▶
Select a suitable fixing material for the weights used
(diameter: at least 10 mm).
▶
Drill a hole into the centre of each weight.
Screwing the rack onto weights
▶
Take hold of the first rack already secured in the installa-
tion angle.
▶
Screw the front rack feet onto the first weight.
▶
Screw the rear rack feet onto the second weight.
◁
The first rack is installed so that it is stable.
▶
Install the second rack on the next two weights as de-
scribed above.
▶
Fit as many racks as you need to hold the collectors.
4.5.2
Installing collectors
Danger!
Personal injury and material damage due
to a falling collector.
Improper fastening may cause a collector to
fall.
▶
Tighten the clamping elements.
▶
Check for proper tensioning by shaking
the clamping blocks.
▶
If a clamping block moves, tighten the nut
again.
1.
Install the collectors on the roof as specified in the fol-
lowing sections.
Sliding on mounting rails
1
2
3
2.
Slide the two mounting rail onto the top and bottom
retainers, as shown in the figure.
3.
Ensure that the open side of the bottom mounting rail is
facing upwards and that the open side of the top mount-
ing rail is facing downwards.
4.
Slide the mounting rail onto one retainer
(1)
first.
5.
Slide the mounting rail a little outwards
(2)
.
6.
Then slide the mounting rail back onto the other retainer
(3)
.
7.
Perform these steps one after the other for all racks.
