Vagner Pool VArio DIN module, User Manual

Page: 27 / 64

11
7.6. Controlling the VA SALT SMART chlorinator with RC module
In order to review or modify the pool water parameters and review the operating status
of a saltwater chlorinator on your RC module, follow these steps:
1. Chlorinator must be connected to the DIN module with a communication cable.
The following steps refer to the
VA SALT SMART chlorinator
(2 “ON“ / 3 “OFF“)
,
DIN module configuration:
Under the DIN module front cover (black) a label shows the required positions of DIP switches
for the connected device =
VA SALT SMART .
2. Press the
“ “
button to wake the RC module from sleeping mode,
3.
In the default RC screen, press the “
<>
“ button to switch to the chlorinator screen (view could
be changed only if the chlorinator unit is connected by the communication cable to DIN
–
for
more details about connection go to section 3 of this manual). If there is no chlorinator unit
connected to the DIN module, the chlorinator screen will not appear!!!
“
<>
“
Note:
The saltwater chlorinator unit can signalize the operating mode and also alarms/notifications . In case of an alarm, the
alarm can be reset only on the chlorinator unit
–
not via VArio
–
by pressing the
“
OK
“
button.
Filtration [ON]
Dosing [ON]
Temp 22°C
[ON]
Lights 014 Atr 015
PH=7.1
[≤7.2]
RX=610mV
[≥700]
Power 25%
Mode Automat.
Illustrative image