background image

Zoo     Sense

 

Vado

Wedmore Road, Cheddar, Somerset, England BS27 3EB

tel 01934 744466.      fax 01934 744345

[email protected]

www.vado-uk.com

  Guarantee

  Customer/technical services

For any technical or installation queries please contact Vado on 01934 745163.

GUARANTEE REGISTRATION

NAME
ADDRESS

RETAILER
ADDRESS

PURCHASE DATE
PRODUCT DESCRIPTION
WHO INSTALLED THE PRODUCT?
FOR VADO USE

POSTCODE

POSTCODE
ARTICLE NUMBER

(SEE BOX)

RETAILER

PLUMBER

BUILDER

SELF

This product is guaranteed against manufacturing defects from the date of purchase until the expiry of the relevant 
guarantee period shown below.

The guarantee is only valid if:-

1. The product has been installed, used and maintained in accordance with Vado’s instructions and subjected to 
normal use only.
2. The defect is not due to use of an unsuitable or inadequate water or power supply.
3. The defect is not due to accident, misuse, neglect or repair other than by Vado or Vado authorised agents or 
damage caused by foreign objects or substances.
4. We have received from you the completed Guarantee Registration Form. Vado accepts no responsibility for any 
forms lost in the post and returns by registered means is therefore recommended.
Under this guarantee (which is non-transferable) Vado will, at its option, repair or replace free of charge any product 
(or replacement part) found to be defective. The guarantee does not extend to any consequential loss or damage. 
After repair or replacement the relevant guarantee period will be calculated from the original date of purchase.

The relevant guarantee periods are:-

1. Twelve years on chrome finish products.
2. Three years on all other products with the exception of Stuart Turner Pumps which carry a 2 year Guarantee on 
Monsoon Range and 1 Year Guarantee on Showermate Range.
All claims under the guarantee must be submitted in writing to the person who supplied the product to you and 
must be received no later than the last day of the relevant guarantee period. All claims must be accompanied by 
proof of purchase (sales receipt or delivery note).
Vado operates a policy of continuous product development and therefore reserves the right to change the product, 
packaging and documentation specifications without notice.
This guarantee is in addition to and does not affect your statutory rights as a consumer.

Mono basin mixer with

1¼” pop-up waste

Installation & maintenance instructions 

Please leave these instructions with the customer

Mono bidet mixer with 1¼” 

pop-up waste

NOTE: For illustrative purposes only the Mono basin mixer with pop-up waste is shown.  

Please follow the same procedure to install the Mono bidet mixer.

Summary of Contents for Zoo

Page 1: ... which is non transferable Vado will at its option repair or replace free of charge any product or replacement part found to be defective The guarantee does not extend to any consequential loss or damage After repair or replacement the relevant guarantee period will be calculated from the original date of purchase The relevant guarantee periods are 1 Twelve years on chrome finish products 2 Three ...

Page 2: ...ions are made to the mains cold water supply WRC approved single check valves must be fitted to both hot and cold inlets This is a stated requirement of Water Supply Water Fittings Regulations 1999 Schedule 2 Section 6 G15 13 2 Before making any inlet pipe connections all supply pipes MUST be thoroughly flushed to remove debris Failure to do so could result in damage or low flow from the mixer uni...

Page 3: ...om right to left will increase the water temperature Pull the vertical control rod up to close the waste outlet and push down to open on up off down hot left cold right 45mm 145mm 1 2 Mono basin mixer Minimum operating pressure 0 2 bar Maximum operating pressure 5 bar Mono bidet mixer Minimum operating pressure 0 3 bar Maximum operating pressure 5 bar 1 1 4 300mm 138mm ...

Page 4: ...connected to the left hand pipe Base ring Rubber washer Metal washer Threaded rod Nut Flexible pipes Control handle Aerator Dissemble the pop up waste and reassemble onto the basin Insert the vertical control rod with knob down through the hole in the back of the mixer body Unscrew the ball joint retainer on the side opening of the pop up waste Insert the short end of the horizontal control rod wi...

Reviews: