12
Installation - trim
Temperature handle (left)
Ensure the temperature handle is correctly
located with the handle stop at 12 o’clock
(see right). Screw the shroud assembly to
the valve whilst holding the handle.
Flow handle (right)
Screw the shroud assembly to the valve
whilst holding the handle. Make sure
that the handle mark is in the 12 o'clock
position.
Please note:
if the handle/shroud
assemblies do not align, remove the offset
spline and replace the other way up (see
right).
Handle stop at
12 o’clock
Inside of
temperature
handle
The handset holder has slight adjustment. Guide the handset holder onto the
spigot first and then slide the cover plate over the shrouds.
Push the cover plate
up to the wall and tighten the two grub screws on the underside of handset holder
to secure it to the spigot. Apply a thin bead of silicone around the outside to seal
against the tiled surface.
13
Installation - handset
Handset outlet
Place a rubber washer into the nut end
of the hose and attach it to the handset
outlet (see above).
Handset
Place the other rubber washer into the
cone end of the hose and screw to the
handset
(see right)
.
Rubber
washer
Nut
Rubber
washer
Handset
Cone end
of hose
Flow
Handle
Shrouds
Cover
plate
Temperature
Handle
Handset
holder
Spigot
Shrouds
Handle
mark
Offset
spline
