6
7
Installation
The length of the overflow pipe can be adjusted by pulling apart or pushing together the
inner and outer overflow pipes.
Should you need to reduce the length even more, pull the outer overflow out of the
collet, cut both the outer overflow pipe and the inner overflow pipe to the required
length, remove any burrs and reassembly.
Ensure all calculations are correct before cutting pipes.
Remove the blanking plug(s) from the overflow assembly. Using PTFE tape fit the inlet
elbow(s).
Push the rubber seal onto the overflow/waste assembly, and from the outside hold in
place over the bath overflow hole.
Screw on the overflow housing, tighten with an hex key.
Caution: do not overtighten as this may damage the parts and/or the bath.
Place the overflow fascia over the overflow housing, make sure the slots for the outlet
and overflow are on the underside. Tighten by screwing the grubscrew located on the
underside of the overflow fascia.
Connect to the supply pipe work.
3
4
1
2
3
4
0 5
1
2
3
4
0 5
1
2
3
4
0 5
1
2
3
4
0 5
1
2
3
4
0 5
1
2
3
4
0 5
2
Installation - Quick guide
2
3
1
6
4
5
Overflow/waste
assembly
Rubber seal
Overflow
fascia
Inner overflow pipe
Inlet elbow
Inlet elbow
Overflow
housing
Hex key
Hex key socket
Outlet and
overflow slots
Outer overflow pipe
Collet