6
7
Installation
Warning!
Please check for any
hidden cables and pipes before drilling
holes in the wall.
Note:
Make sure that the valve is
positioned to allow room for the riser to
be fitted (see dimensions - page 5).
Prepare the wall with 2
x
½"copper
pipes at 150mm centres. Connect the
water supply to the inlet pipes. The hot
water should be connected to the left
hand pipe.
150mm
Screws
Remove the nut and olive from the
connector.
Suitably fix the easy-fit bracket to the wall
using appropriate fixings.
Repeat for the other
easy-fit bracket
Position the valve making sure it is level
and mark the position of the 2 screw
holes in each easy-fit bracket.
Temporarily screw both easy-fit
connectors onto the valve.
Easy-fit
connector
½" Copper pipe
½" Copper pipe
Cold
Hot
Installation
Olive
Nut
Shrouds
Slide on the olive, screw on and tighten
the nut.
Before installation flush through the
pipe work to ensure removal of debris,
turn off the water supply.
Locking nuts
Easy-fit connectors
Screw the shrouds on each easy-fit bracket.
Place a rubber washer in each of the locking nuts on the valve and screw onto the
easy-fit brackets.
Rubber
washers
Summary of Contents for AXCES AX-SIR-123T-RRK/B-CP
Page 9: ...17 16 Notes Notes...
