Vaderstad NZ Aggressive NZA 600 Series, Original Instructions Manual

Page: 32 / 50

Instructions and adjustments
32 11.07.2011
ver. 2
3.11.3 Stabiliser rod
Upon delivery of the implement, the stabiliser rods are fitted on the Crossboards. The stabiliser
rods should only be disassembled in exceptional cases, such as when driving on extremely light
soil or in very humid conditions.
Fitting the rods
Fold up the harrow. Make sure the locking devices on the wings are set in place. Close the cock
on the wing folding hydraulics. See “Figure 4.5” or “”. Raise the harrow from the ground until
the Crossboard tines do not touch the ground. Fit the stabiliser rods onto the centre section.
Fold down the harrow to the work position. Install the stabiliser rods in the wing sections making
sure they point in the direction of the harrow centre.
!
On the NZA 500 ST and NZA 600T, the wing section stabiliser rods for the front Crossboard
must be installed from inside and point outwards.
Figure 3.23