Vaderstad NZ Aggressive NZA 600 Series, Original Instructions Manual

Page: 17 / 50

NZA 500-1000 /T/ST
11.07.2011
ver.2
17
2.6 Fitting the rear Crossboard (option)
Figure 2.6
The Crossboard sections should be screwed onto the brackets on the harrow frame. They can be
fitted at two different height positions. The figure shows the standard fitting.
Figure 2.7
Fit the parallel rods between the lifting arms on the front and rear Crossboards. Fit the rods in the
rear hole on the rear lifting arms (see position B). The rods must be parallel in the longitudinal
direction of the harrow. The grease nipple next to the crank must point upwards.
Fit the rods on the correct side of the lifting arms to avoid that the rods touch the hoses and con-
nectors on the Crossboard hydraulic rams. See position A. Note that the screws act as a joint and
as such must not be tightened. Lock the screws using lock nuts on the opposite side of the lifting
arms.
A
B
NZA 500-600