Securing the Tile Bridge
1. Optional: Use four 10-24 x 5/8 in. screws to secure the tile bridge to the ceiling framework and prevent
shifting. For 600mm frameworks, install the screws through the outer face of the adjustable end
brackets. For larger frameworks, install the screws through the inner face of the brackets.
2. Slide a cable lock onto each support wire. The wire will only pass through each opening in one direction.
3. Pass the end of each wire through the hole at the nearest corner of the tile bridge, and back through the
cable lock.
Caution: You must adjust the support wires to support the full weight of the
tile bridge, so that the mounting system does not place any load on the
framework supporting the ceiling tiles. Failure to do so will damage the
framework.
4. Adjust the cable tension until the tile bridge is supported fully and evenly by all four support cables,
without putting any weight on the ceiling tile framework. If you overtighten a support wire, use the
release lever on the side of the cable lock.
12
Installation Guide for the QuickCAT Universal Ceiling Mount for PTZ Cameras
