ProductionVIEW Precision Camera Controller
ProductionVIEW Precision Camera Controller Manual 341-770 Rev H
Page 10 of 16
System Menu (continued)
>Serial Echo
>Select
>Yes or No
Turns Serial Echo on or off (default is Yes or On)
>Serial Info
>Select
>On or Off
Reports button pushes on front panel out the serial port (default is off)
(Does
not
report
joy
stick
position)
>Panel Lights
>Select
or
Cancel
>00
through
50
Panel Light Brightness (all lights - 50 is the brightest) (default is 25, off is 00)
>Clear Memory
>Select
>Start
>Clear Presets
>Select
>Start
Note: Clears only local presets in Precision Camera Controller, not in camera presets.
>Power Up Preset
>Select
>Home
Camera
>Select - Upon power up, all cameras will go to their home position
>Preset
14
> Select - Upon power up, all cameras will go to Preset 14
>Preset
Location
>Local
>6
InCam
8
Local
In “Local” mode, the ProductionVIEW stores all 14 presets internally
In “6 InCam 8 Local” mode, the presets 1 through 6 will be stored in the cameras.
Presets 7 through 14 will be stored in the Precision Camera Controller.
Note:
The “6 InCam 8 Local” mode allows for switching video sources when Sony cameras are moving to
preset locations. Since Presets are stored in camera, the system does not have to wait for position
feedback before allowing another command to be entered.
>Dual
Link
>Select
>On or Off
Notes:
In Dual Link mode, an external video switcher may not be connected to the RS-232 port.
Both Precision Camera Controllers must be set to “Control A” under Camera Select Bus.
>Video
Switcher
>Select
>None
Edirol 4H, 3S
Innovation by Isis
User Defined (for future use)
>Transition
Time
(External)
>Select
> (0.0 to 4.0 seconds)
>Tally
Outputs
>Select
>Active High
Active Low
