Connections for HDMI Cameras
In this configuration, the OneLINK Bridge extends network connectivity, power, and control to an HDMI
camera, and brings HDMI video from the camera to a display. The camera can optionally be controlled by a
camera controller on an RS-232 serial connection to the OneLINK Bridge or over the network, depending on
the controller. The OneLINK Bridge also provides connections for microphones and speakers, and can
originate a USB stream to bridge the non-USB camera and audio equipment into a USB-based
conferencing application.
If an IP stream is available from the camera, the OneLINK device passes it to the network. IP streaming
resolutions up to 2160p/30 are supported. HDMI output resolution and streaming parameters (including
resolution) are configured on the camera, not the OneLINK device.
Kits for HDMI Cameras
This block diagram applies to:
n
OneLINK Bridge AV interface for Polycom cameras with Polycom Codecs, 999-9620-000/001/009,
when used without a codec – compatible with Polycom EagleEye IV camera.
n
OneLINK Bridge AV Interface for Sony and Panasonic Cameras, 999-9630-000/001/009 – compatible
with Panasonic HE-series, Sony EVI-D series, and Sony BRC-H series cameras.
n
OneLINK Bridge AV interface for Cisco Cameras with Cisco Codecs, 999-9660-000/001/009, when
used without a codec – compatible with Cisco Precision series cameras.
n
OneLINK Bridge AV Interface for RoboSHOT HDMICameras, 999-9690-000/001/009
22
Installation Guide for the OneLINK Bridge AV Interface
