PRO MIC I/O
Vaddio PRO MIC I/O - Document Number 342-0569 Rev A
Page 8 of 16
S
TEP
-
BY
-S
TEP
I
NSTALLATION
I
NSTRUCTIONS
EasyUSB Mixer/Amp Installation:
Locate the EasyUSB Mixer/Amp in a centralized location within the conference room within 6 feet of the PC.
Follow steps below to install the devices:
Diagram: Basic System Connections
Before Starting:
Please read and fully understand the information in the EasyUSB Mixer/Amp Manual.
STEP 1:
Connect the Cat-5 cable between the EasyUSB Mixer/Amp and the PRO MIC I/O using the RJ-45 EasyMic Ports.
STEP 2:
Plug the microphones into the XLR-F connectors on the back panel of the PRO MIC I/O.
STEP 3:
Set the desired microphone preamp gain for each microphone input from the front panel of the PRO MIC I/O.
Enable/Disable Phantom Power and Filters as Required.
Optional Accessories
: The PRO MIC I/O has an accessory rack kit:
Rack Mounting Kit:
The rack kit provides a method for a single PRO MIC I/O to be installed in a 1-RU
space, providing space for adequate cooling and room for cabling within
the rack. The Rack Kit includes two
rack ears (one long and one short). The rack ears are mounted on the sides of the PRO MIC I/O using the
existing screws included on the device.
PRO MIC I/O Rear Panel
STEP 1
STEP 2
EasyUSB
Mixer/Amp
Pro Table
Mics
Cat-5 EasyMic
Port Connection
Space Shuttle Not Included
