Back of the Camera
From left to right:
n
12 VDC, 3.0 Amp power connector
– Connect only the power supply shipped with the camera
n
USB 3.0 video device connector
for streaming uncompressed UVC standard video
n
Ethernet RJ-45
for IP streaming, access to web interface and Telnet for camera control
n
RS-232 port
on shielded RJ-45 connector for legacy controllers
n
DIP switches
to set IR frequency, IR on/off, and image flip (camera is invertible)
Switch Settings
Use the DIP switches to set camera behaviors.
IR Frequency Selection:
The IR Remote Commander can control up to three cameras in the same room
with different IR frequencies. Use
switches 1 and 2
to select the frequency to identify the camera as
camera 1, 2, or 3; then use the Camera Select buttons at the top of the remote to select the camera you
want to control.
Inverted operation:
If mounting the camera upside-down, set
switch 3
to the DOWN position: IMAGE
FLIP ON.
Switch 4
is not currently used.
Note
The web interface provides baud rate and super-wide mode settings. See
Soft Switch Settings, Reboots, Resets, and Updates
6
Integrator's Complete Guide to ClearSHOT 10 USB Enterprise-Class PTZ Conferencing Cameras
