What is it doing?
Possible causes
Check and correct
The camera's RS-232 settings
don't match the settings on the
controlling device.
Check the settings at both ends to be
sure they match. The camera's baud
rate can be viewed or changed on the
System page in the web UI.
The camera loses all its
settings when power is cycled.
All the DIP switches are in the
ON (down) position.
Set the DIP switches to their proper
positions. Default is all OFF (up). See
for more information.
No H.264 video stream.
IP streaming is not enabled.
Enable IP streaming: Streaming page in
the web interface.
No USB video stream.
USB streaming is not enabled.
Enable USB streaming: Streaming
page in the web interface.
Indicator light continues to blink
blue.
The USB cable is not
connected.
Connect the USB cable.
Restoring default camera settings
Set all DIP switches DOWN and cycle the power to reload the default camera settings. Then return all DIP
switches to the desired settings.
Operation, Storage, and Care
For smears or smudges on the product, wipe with a clean, soft cloth. Use a lens cleaner on the lens. Do not
use any abrasive chemicals.
Keep this device away from food and liquids.
Do not operate or store the device under any of the following conditions:
n
Temperatures above 40°C (104°F) or below 0°C (32°F)
n
High humidity, condensing or wet environments
n
Inclement weather
n
Severe vibration
n
Between converging tectonic plates
n
Dry environments with an excess of static discharge
Do not attempt to take this product apart. There are no user-serviceable components inside.
52
Integrator's Complete Guide to ClearSHOT 10 USB Enterprise-Class PTZ Conferencing Cameras
