VADA - V110-H
PREPARING FOR INSTALLATION
Inspect your pump, ensuring that it is well packaged and has not been damaged in transport. If the pump is damaged, report it to the Reece
branch where the pump was purchased. Make sure the suction piping is completely air tight and is laid so that there can be no air locks.
Warranty of these pumps is void unless they are operated in accordance with these instructions.
PUMP PROTECTION
The pump should be protected from the weather, floods, chemicals, dust, vermin and insects. It is recommended that the pump be housed in a
weather proof, well vented enclosure.
The pump is designed to be used with clean water
in a residential application. Do not use it with
alternative fluids, specifically abrasive, corrosive
or explosive fluids. Do not install or operate your
pump in an explosive environment or near
combustible matter.
Incorrectly installed or tested equipment may fail,
causing severe injury or property damage.
Fire and burn hazard. Modern motors run at high
temperatures. To reduce risk of fire, do not allow
leaves, debris, or foreign matter to collect around
the pump motor. To avoid burns when handling the
motor, let it cool for at least 20 minutes before
trying to work on it. A thermal overload switch
protects the motor from heat damage during
operation.
If the supply cord is damaged, it must be replaced
by the manufacturer, it’s service agent or similarly
qualified persons in order to avoid a hazard
Children should be supervised do ensure they do
not play with the appliance
Only qualified, licensed personnel should install
pump. The electrical installation shall be in
accordance with the national wiring rules (AS/NZS
3000) for class 1, IP44 rated products.
These instructions are a guide only. Users not
familiar with pumping equipment should seek
advice from people experienced in pump equipment
and installation.
Freezing conditions will damage the unit, because
when water freezes it expands. Ensure that the
pump is located so that it is not prone to freezing,
or ensure that the product is disconnected and
dried of water during cold conditions.
The pump is electrically connected. Ensure that it
is isolated from electrical supply during installation
and any subsequent service work.
This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervi-
sion or instruction concerning use of the appliance
by a person responsible for their safety
INSTALLATION
Please pay careful attention to the following warnings signs and indications.