WIRELESS REMOTE TRANSMITTER
OPERATION (LEGACY)
The wireless remote transmitter should be located in a
convenient place inside the cab.
1. Push the green button (Fig. 1-6, 1) to turn the wireless
remote transmitter on.
Fig. 1-6
2. Press the top left button (Fig. 1-6, 3) to create vacuum
on the pad and lift the load.
3. To release the load, press and hold the top left and the
top right buttons (Fig. 1-6, 3 and 4) at the same time.
For safety purposes, there will be approximately a three-second
delay on the release function.
4. To turn the wireless remote transmitter off, push the red
button (Fig. 1-6, 2).
5. The wireless remote transmitter and the receiver are
a matched system and can not be used with other
systems.
operation
RC SERIES
NOTICE
1
2
3
4
LIFT A LOAD
Do not activate vacuum when pad is not on material to be
lifted. If pad is not properly placed on material when vacuum
is activated, the vacuum in the reservoir might be lost.
Therefore, watch the pad gauge when activating vacuum.
Shutting off vacuum quickly could prevent vacuum loss and
time loss.
1. Properly position the vacuum pad on the material to be
lifted before activating vacuum.
Fig. 1-7
2. With wireless remote transmitter (Legacy) on, press
the top left button to activate vacuum. With wireless
remote transmitter (Production) on, press the green
button to activate vacuum.
3. Both the reservoir gauge and the pad gauge readings
should be approximately in the same range. Do not
attempt to lift if the gauge is in the red.
4. If the pad gauge does not read in the green, shut off
vacuum and inspect if the pad is correctly sealing on
the load.
5. Slowly lift the load up. If traveling with the load,
always carry it low.
6. Do not lift the load over anyone. When rotating,
always rotate slowly.
