RC SERIES
operation
WIRELESS REMOTE TRANSMITTER
OPERATION (PRODUCTION)
TURNING ON THE REMOTE
The wireless remote transmitter should be located in a
convenient place inside the cab.
1. To turn on hold red button (Fig. 1-5, 1), then hold green
button (Fig. 1-5, 2), then release red button and green
button in succession.
Fig. 1-5
STARTING THE LIFTER ENGINE
2. Make sure the remote is on (may take up to 30 seconds
to sync with the lifter). When sync is complete, the
green or amber light will come on the lifter. Leave the
key in the off position. Press and hold the bottom left
button (Fig. 1-5, 3).
LIFTING AND RELEASING LOADS
3. To lift load hold green button (Fig. 1-5, 2) for 1-2
seconds to create vacuum on the pad. Monitor gauge
until it reaches green area. Then it is safe to lift the load.
4. To release load hold top 2 circle shaped buttons (Fig.
1-5, 4) simultaneously for 4 seconds to start releasing
vacuum. When gauge hits zero, it is safe to remove pad
from the load.
For safety purposes, there will be approximately a three-second
delay on the release function.
TURNING OFF THE LIFTER
5. Press and hold the middle 2 circle shaped buttons (Fig.
1-5, 5) simultaneously for approximately 5 seconds,
until the lifter’s engine powers down completely.
TURNING OFF THE REMOTE
6. To turn off press the red button (Fig. 1-5, 1) or device
will automatically shut off after 24 hours of inactivity.
7. The wireless remote transmitter and the receiver are
a matched system and can not be used with other
systems.
NOTICE
2
1
4
5
3
