page 40 of 76
VACUU•SELECT Controller
Connect the VACUU•SELECT operating panel to the
VACUU•BUS cable of the VARIO diaphragm pump.
For proper operation of the VARIO select pump a pres-
sure transducer (e.g., VACUU•SELECT Sensor, etc.) has
to be connected to the operating panel.
The VACUU•SELECT Controller can only be operated
with components compatible with the VACUUBRAND
VACUU•BUS system, (see “Accessories”, pg. 52).
The vacuum controller controls VACUUBRAND VARIO
diaphragm pumps and optional coolant and venting
valves. Connected components (e.g., venting valves,
VACUU•SELECT Sensor, etc.) are automatically identi-
fied when switching on the operation panel.
Identical com-
ponents must be configurated beforehand, see manual of
VACUU•SELECT Controller.
Attention
: Do not apply off-axis forces when assembling
or removing plug connections! Observe correct orienta-
tion of the plug.
To connect further components use VACUU•BUS Y-adapt-
ers and extension cables.
Do not use more than one controller within the same
VACUU•BUS system.
Several controllers in the same VACUU•BUS system
will interfere with each other and result in error mes-
sages of the connected components (pumps, valves).
VACUU•SELECT Sensor
The VACUU•SELECT Sensor is equipped with a capaci-
tive pressure transducer with ceramic diaphragm. It mea-
sures the actual pressure independently of the gas type,
and with reference to the vacuum, i.e., absolute.
Connect the VACUU•SELECT Sensor via the VACUU•BUS
cable to the operating panel.
