4
Position Cover Plate over the Mounting Bracket and with a Phillips handheld screwdriver and secure the Machine Screws
into the 2 center holes. Then install the Rubber Sleeve onto the Safety Stop.
REPEAT STEPS 1 THROUGH 2 ON THE OTHER SIDE
Position all four corners of the Cover squarely on of Spa.
Position a Teflon Washer over the “Boss” closest to the rear of the spa and below the
“Safety Stop”. Then Position the Swing Arm on the Boss. Make certain the extended
portion of the Swing Arm is positioned towards the interior of the spa (See Fig 8).
Then over the center hole position place a 2nd Teflon Washer, followed by a Machined
Washer, then a Lock Washer, and secure with 5/16 Hex Bolt. Tighten until the Lock
Washer is compressed.
Slide the Adjustable Bracket onto the Swing Arm (See Fig 8) making certain the
larger oblong hole is positioned toward the bottom and towards the rear of the
spa when the Swing Arm is in the up position.
NOTE: Leave Adjustable Bracket Unsecured.
Slide the longer side of the “Crossover Bar” through the Upper Clamp then slide
the shorter side of the “Crossover Bar” into the Swing Arm (See fig 9, 9B) with the
Adjustable Bracket on it. Position the Clamp on top of the cover above the slit and
as close to the cover fold as possible.
NOTE: Leave both the Swing Arm and “Crossover Bar unsecured.
STEP 2 – INSTALL “COVER PLATE” (See Fig 6B)
STEP 3 – POSITION COVER ON THE SPA
STEP 4 – INSTALL“ SWING ARM”
STEP 5 – SLIDE ON “ADJUSTABLE BRACKET”
STEP 6 – POSITION “CROSS OVER BAR” & UPPER CLAMP
Figure 8
Figure 9
N) Lock
Washer
M) Black
Fender Washer
Z) Teflon
Washer
S) Hex
Bolt
IMPORTANT : If length of the cover on fold side is less than 78” you may have
to cut Swing Arm using a tube cutter. This can be determined by following
instructions in Step 8 (position “Cross Over-Bar and “Upper Clamp” over cover
slit and slide in the “Swing Arm”). If cutting is required, make certain to
measure and allow at least 4” of the Swing Arm to pass into the Crossover Bar
so that it is visible through all of the pre-drilled holes.
IMPORTANT : If the width of the cover is less than 66”, than it will require
cutting both sides of the Crossover Bars equally to accommodate the short
width, along with possibly shortening the Extension Tube if necessary.
Figure 9B
Swing Arm
Crossover Bar
(short side)
Upper Clamp
Slit in
Cover Flap
Crossover Bar
(long side)
