background image

• 

Do not leave room when hose is 

plugged   in to the inlet.  Disconnect power 

before servicing.

• 

Electric shock could occur if used on wet 

surfaces.

• 

Do not allow to be used as a toy.  Close 

attention is necessary when used by or  

near children.

• 

Use only as described in this manual.  

Use only those attachments that are rec-

ommended.

• 

Do not use with damaged cord or plug.  

If applicance is not working as it should, has 

been dropped, damaged, left outdoors, or 

dropped into water, return it to a service 

center.

• 

Do not pull or carry by cord, use cord as 

a handle, close a door on cord, or pull cord 

around sharp edges or corners.  Do not run 

appliance over cord.  Keep cord away from 

heated surfaces.

• 

Do not unplug by pulling on cord.  To 

unplug, grasp the plug, not the cord.

• 

Do not handle plug or appliance with 

wet hands. 

• 

Do not unplug hose from system by 

pulling on vacuum hose.  To unplug hose, 

grasp the cuff, located on the end of the 

hose, pull out with a twisting motion.  

• 

Do not put anything into vacuum inlet or 

vents.  Keep inlet free of things that might 

slow airflow, such as lint, dust and hair.   Do  

not  use  the vacuum system if something 

is blocking an opening.

When using an electrical appliance, basic precautions should always be 

followed, including the following: 

 * 

Read all instructions before using  this appliance.

WARNING:  

To reduce the risk of fire, electric shock or injury:

 * 

Always follow these safety instructions

IMPORTANT SAFETY INSTRUCTIONS

•  If equipped with an air turbine power  

brush unplug  the  vacuum hose before  

attaching power brush.  Keep fingers,   

hands and toes away from the base of the 

power brush.  Failure to do so could result in 

injury from moving parts.

•  Not intented as a wet pickup. Do not use 

to pick up liquids of any kind.    Doing so will 

void warranty.

•  In  the  event  the  power  unit  should 

get wet, do not use the vacuum system 

until it has been properly serviced and  

examined by a serviceman or installer.

•  Keep hair, loose clothing, fingers and all  

parts of the body away from wand, other 

openings and moving parts.

•  If  so  equipped,  do  not  use  your  vacuum 

system without dustbag in place.

•  Always disconnect vacuum system before  

emptying dirt canister or replacing dustbag.

•  Use extra care when cleaning on stairs.
•  Do not use to pick up flammable or  com

-

bustible liquids such as gasoline or use in areas 

where such liquids may be present.

•  Do not use to pick up dry wall or cement  

dust.  Doing so will void warranty.

•  Do  not  pick  up  anything  that  is  burn

-

ing or smoking, such as cigarettes,  

matches  or hot ashes. 

•  When finished put the vacuum hose and at

-

tachments away to prevent tripping accidents. 

•  For a grounded appliance, connect to a  

properly grounded outlet only.  See    

grounding instructions. 

Summary of Contents for UV100













Reviews: