Vacmaster VWM510, Operator'S Manual

Page: 7 / 17

7
GENERAL ASSEMBLY INSTRUCTIONS
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT EXPOSE TO RAIN.
MAKE SURE PLUG IS DISCONNECTED BEFORE ASSEMBLING THE WET/DRY VAC.
WARNING:
UNPACKING YOUR WET/DRY VACUUM & GENERAL ASSEMBLY
1. Verify that the power cord is disconnected from the outlet. (fig. 1)
2. Undo the latches. (fig. 2)
3. Lift the power head off the collection tank. (fig. 3)
4. Remove the contents from inside the collection tank; make sure you have all contents as listed
on page 6. (fig. 4)
5. Replace the power head to the collection tank and insert the noise diffuser into the blower port.
(fig. 5)
MOUNTING RACK AND STORAGE ASSEMBLY
IMPORTANT!
• Do not mount the rack over 5 feet from the floor.
• Do not screw the rack to drywall only. Secure the screws to a stud.
• Do not hang from or sit on the mounting rack
• Do not exceed the 40 pound maximum weight limit.
6. Insert the hose storage rod into the two holes located on the top of the mounting rack. Make
sure the bend of the rod is directed away from the wall. (fig. 6)
7. Select a location on a wall stud that is not more than 20 feet away from an electrical outlet.
8. Align the three screw holes so that they are over a stud. Make sure the rack is level and mark
the hole locations. Make a 1/8-inch diameter pilot hole in each marked location. Secure the
mounting rack to the wall stud with the three screws provided. (fig. 7)