14
RESETTING THE REMOTE CONTROL
Resetting The Remote Control
Changing The Battery – Replace With A 23AE 12V Alkaline Battery Only
1. Set the power switch to remote control position “ ”. (fig. 1)
2. Press the RESET button on the side of the power head with a pen tip until the indicator lights
up. (fig. 2)
3. Within 15 seconds, press and hold the “ON” or “OFF” button on the remote control. If you didn’t
press and hold the “ON” or “OFF” button within 15 seconds, it will cancel this resetting. (fig. 3)
4. When the light blinks 3 times, this means the remote control is programmed.
1. Take a Phillips screwdriver and remove the screws on the remote control. (fig. 1)
2. Slide back the remote cover so that the white triangle on the remote cover points to the unlock
symbol “ ”. (fig. 2 & 3)
3. Remove the remote cover from the handle. (fig. 4)
4. Lift the foam cover to expose the battery and remove the old battery. (fig. 5)
5. Insert the new battery with the terminals in the direction shown and make sure to replace the
foam cover. (fig. 6 & 7)
6. Replace the remote control by aligning the white triangle on the side cover to the unlock symbol
“ ” on the handle. (fig. 8)
7. Slide the remote cover so that the white triangle is over the locked symbol “ ”. (fig. 9 & 10)
8. Secure the cover with the screws. Do not over-tighten. (fig. 11)
Summary of Contents for VWM510
Page 16: ...16 EXPLODED VIEW ...
