Vacmaster VBVA1010PF, Operator'S Manual

Page: 7 / 32

7
DRY VACUUM OPERATION
DRY VACUUMING
WARNING:
BE SURE TO READ, UNDERSTAND, AND APPLY, INFORMATION
ENTITLED ‘SAFETY INSTRUCTIONS & WARNINGS’. DO NOT VACUUM IN AREAS WITH
FLAMMABLE GASES, VAPORS, OR EXPLOSIVE DUSTS IN THE AIR. FLAMMABLE
GASES OR VAPORS INCLUDE BUT ARE NOT LIMITED TO: LIGHTER FLUID, SOLVENT
TYPE CLEANERS, OIL-BASED PAINTS, GASOLINE, ALCOHOL, OR AEROSOL SPRAYS.
EXPLOSIVE DUSTS INCLUDE BUT ARE NOT LIMITED TO: COAL, MAGNESIUM, GRAIN,
OR GUN POWDER. TO REDUCE THE RISK OF HEALTH HAZARDS FROM VAPORS OR
DUST, DO NOT VACUUM TOXIC MATERIALS.
1. Verify that the power cord is disconnected from the outlet. (Fig. 1)
2. In order to prepare your vacuum for dry vacuuming, verify that the cartridge filter is securely
mounted. Make sure the filter is pushed in until it stops against the power head. Your Wet/Dry
Vac comes with the cartridge filter pre-installed. For installation instructions, see page 13.
3. Place the power head back on the collection tank, and secure it in place using the latches. (Fig.
2)
OPERATING INSTRUCTIONS: DRY VACUUMING
4. Insert the locking end of the hose into the vacuum port and lock in place. (Fig. 3).
5. Choose the desired accessory and insert onto the end of the hose. (Fig. 4)
6. Plug the power cord into the outlet. (Fig. 5)
7. Turn the motor on by pressing the power switch to the ‘I’ (ON) position and begin vacuuming.
(Fig. 6)
8. Once you have completed vacuuming, press the power switch to the ‘O’ (OFF) position and
unplug the power cord from the outlet.
O = OFF I = ON
DO NOT USE THE CARTRIDGE FILTER FOR LIQUID VACUUMING.
CAUTION: Do not vacuum drywall dust, fireplace soot or ash with standard Wet/Dry filter. This
is very fine dust which will not be captured by the filter and may cause damage to motor. When
vacuuming fine dust, use a fine dust filter. To purchase fine dust filters, call 1-866-384-8432 or get
them at your local or online Vacmaster
®
retailer.
4
6
3 1 5
2