Vacmaster DVTB2015, Operator'S Manual

Page: 14 / 22

14
GB
NOTE: THE FILTERS PROVIDED ARE SUITABLE FOR BOTH WET AND DRY USE VACUUM
OPERATION. THE USER IS NOT REQUIRED TO CHANGE THE FILTER FOR EITHER
OPERATION. IT IS ADVISED TO LET ONE FILTER COMPLETELY DRY BEFORE CHANGING
TO DRY USE VACUUMING TO AVOID BLOCKAGES AND BUILD UP DEBRIS. THESE
INSTRUCTIONS LISTED ARE VALID FOR BOTH WET AND DRY EXTRACTION.
IMPORTANT! WHEN VACUUMING LIQUIDS, DO NOT IMMERSE THE NOZZLE COMPLETELY
IN THE LIQUID; LEAVE A GAP AT THE TIP OF THE NOZZLE TO ALLOW AIR INFLOW.
THE MACHINE IS FITTED WITH A FLOAT VALVE THAT STOPS THE SUCTION ACTION
WHEN THE COLLECTION TANK REACHES ITS MAXIMUM CAPACITY. YOU WILL NOTICE
AN INCREASE IN MOTOR SPEED. WHEN THIS HAPPENS, DRAIN THE LIQUID INTO A
SUITABLE RECEPTACLE. TO CONTINUE VACUUMING, REFIT THE POWER HEAD TO THE
COLLECTION TANK.
1) Verify that the cartridge filter is securely mounted.
2) Firmly insert one end of the hose into the vacuum intake port (Fig. 8).
3) Choose the desired accessories and push the attachment(s) onto the hose nozzle.
4) Fully insert a charged battery pack into the operational/power battery bay (Fig. 9).
5) Turn the motor on by assigning the switch to the 'I' ON position.
6) Once you have completed vacuuming, turn the motor off by switching to the 'O' OFF position.
5. Blower Operation
WARNING: KEEP BYSTANDERS CLEAR FROM BLOWING DEBRIS.
WARNING: WEAR A DUST MASK IF BLOWING CREATES DUST THAT MIGHT BE
INHALED.
1) Make sure the collection tank and any collected waste is emptied before using as a blower.
2) Connect the hose to the blower port located on the side of the vacuum cleaner (Fig. 10).
3) Turn the motor on by assigning the switch to the 'I' ON position.
6. Inflator Nozzle Adapter Operation
6.1 Inflating an object
The included inflator nozzle adapters allow your wet/dry vacuum to be used to inflate items such
as air mattresses and recreational floatation devices.
1) Ensure the collection tank is emptied and connect the hose to the blower port.
2) Push the desired inflator onto the supplied hose nozzle adapter, then connect to the suction
hose (Fig. 11). Turn the vacuum to the 'I' ON position.
3) Turn the motor on by assigning the switch to the 'I' ON position.
6.2 Deflating an object
1) Firmly insert one end of the hose into the vacuum cleaner intake port.
2) Insert the inflater nozzle into the air valve of the item. Turn the vacuum to the 'I' ON position.