Programming Manual
As a replacement for an Astrell or Avidsen (2
nd
or 3
rd
type of receiver)
Second type of receiver:
1. Open the casing of your receiver. It is located next to your motor.
2. On the receiver circuit board, press the button RF. Keep it pressed down. The LED light on the
receiver illuminates (L1). Let the button go.
3. During the following 10 seconds, press the button on your new remote control. Let it go. The
LED light on the receiver blinks.
4. Wait 10 seconds.
5. Your new remote control is programmed.
Third type of receive :
1. Open the casing of your receiver. It is located next to your motor.
2. On the receiver circuit board, press the programming button RX. Keep it pressed down. The
LED light on the receiver illuminates (Ld1). Wait 5 seconds. The LED light on the receiver
turns off. Let the button go.
3. Press a button on your new remote control. Keep it pressed down. The LED light on your
receiver illuminates (Ld 2).
4. Let the button go.
5. Wait 10 second. Your new remote control is programme
Summary of Contents for Phoenix
Page 3: ......
