![background image](http://html1.mh-extra.com/html/v-zug/gk46tim-series/gk46tim-series_installation-instructions-manual_3644216007.webp)
Installation instructions
Induction hob
GK46TIG | GK46TIM | GK47TIMAS
1021071-R01
28/11/2016
7
Installation
1.
Create the mounting cut-out accurately.
– The mounting surface can be recessed by installing wood or stone bars or produced using the steel angle set (see Ac-
cessories).
Access to the appliance from below must be guaranteed over the entire cut-out surface. For servicing, the induction gen-
erator with the mounting plate can be removed from below. It must be possible to unscrew the contact-proof covers from
below.
2.
Prepare the cut-out and appliance in accordance with the specifications in the enclosed cementing-in instruction.
3.
Carefully cement the appliance in place and allow the silicon cement joints to dry for at least 24 hours.
4.
Potentially connect to the electrical mains connection before inserting the appliance.
Installation with oversize mounting frame
The cooking ring layout of the hob to be fitted can differ from the hob illustrated.
GK46TIMSU/O
≥10
*
B
Y – Y
Drawer/cabinet
490–53
0
560–
585
600/550
=
=
A
H
600
545
Y
Y
Ri
Ra
Cable length 1.7 m
* The clearance space must be maintained.
Type
A – loosely based on
manufacturer
B
H
Corner radius Ra/Ri
GK46TIMSU/O
≥30 mm
≥58.2 mm
48.2 mm
10/8 mm
A
Worktop depth (in combination with directly built-under oven)
B
Required clearance in the service exchange
H
Measurement from the top side of the worktop to the underside of the hob (ventilation opening)
Ri
Appliance corner radii
Ra
External corner radii of the cut-out
Installation
1.
Create the mounting cut-out accurately.
2.
Carefully place the appliance in the mounting cut-out and push against the work surface until flat.
The appliances with oversize frames can also be used as an alternative to built-in solid plates and to installation in complete
chrome-nickel steel covers. In the latter case, the built-in solid plate part is cut out of the chrome-nickel steel cover and replaced
by an appliance (depth of the work surface ≥ 30 mm). In contrast to normal installation without a fastening system, the appliance
is fixed from below using adjusting braces.