Installation instructions
Glass ceramic hob
Installation in a glass work surface
J41699-R11
18.8.15
10
See the installation instructions specific to the appliance for general installation notes.
1. Place the hob gently in the cut-out in the glass work surface.
2. Align the hob symmetrically to the cut-out. Ensure that the hob frame seal lies on the glass work surface all the way around.
3. Fix the hob with at least 4 adjusting braces.
Note
•
Installation in a min. 12 mm thick glass work surface with chipboard underneath.
•
Make the cut-outs in the glass work surface according to the instructions in the planning aid.
Framed and flush hobs
The hobs are secured with adjusting braces in place of «klick-in» assembly rails (see diagram).
General notes
Installation
Due to the risk of the glass work surface breaking, take care not to knock the hob against the sides of the cut-out.
In the case of induction hobs, there is no need to install adjusting braces.
A
4
5
Chipboard
Adjusting braces (min. 4×)
Self-tap screw 3.9 × 25
Glass work
surface, tempered
Enamel coating
Toptronic:
Use adjusting brace set H6.2510 in
place of mounting angle
width
d
e
p
th
R*
R*
0
-1
8,5
8
,5
0
/+
1
Detail A
* see table
with fold:
without fold:
