Installation instructions
Range hood
Operating modes: Extraction/recirculation
DWPQ9, DWPQ12
1039460-R01
13/12/2017
1039460-R01
3
Installing
▸
Fix angle bracket
C
to motor housing with 2 screws
S3.
▸
Drill holes for wall angle bracket
W
.
S3
C
▸
Fix wall angle bracket
W
to the wall with appropriate fasteners
(bolt anchors
BA
or rawlplugs
DL
) and 2 screws
S5
▸
Fit hood to wall mounting bracket
W
and screw lightly with 2
nuts
G
.
▸
Align hood horizontally using adjusting screws
S6
.
▸
Mark 2 holes (ø8 mm) for screws
S7
, take down the hood, drill
holes and insert rawlplugs.
▸
Fit hood and tighten nuts
G
.
▸
Fix with 2 screws
S7
(ø5 × 40 mm) and fit dummy covers
D
.
▸
Drill 2 holes (ø8 mm) for screws
S8
– aligned with appliance –
in the wall under the ceiling and insert plugs.
400
750
650
11
90 90
125 125
W
J
S5
W
▸
Fix metal support
J
with 2 screws
S8
(ø5 × 40 mm).
▸
Fix exhaust air hose to exhaust air connector. If non-return
valve flap is used, test after installation to see if functioning
properly.
▸
Make electrical connection (see section on 'Electrical connec-
tions').
▸
For recirculation mode:
Connect diverter piece
K
to exhaust
air hose and screw to metal support
J
with 4 screws
S9
(ø3.5 × 6 mm).
▸
For extraction mode:
Connect exhaust air hose to exhaust air
pipe wall-side.
▸
Fit lagging sheets
L1, L2
. Align lagging sheet
L1
vertically and
screw to metal support
J
with 2 screws
S10
(ø3.5 × 6 mm).
▸
For recirculation mode:
Adjust air outlet grille in side of upper
casing to face upwards.
▸
For extraction mode:
Adjust air outlet grille of upper casing to
face downwards.
▸
Insert grease filters.
▸
Carry out function test.
J
S6
G
S8
S9
S10
K
R
L1
L2
S7
D
