FOR PYD18 EUROPA VENT-A-HOODS
INSTALLATION INSTRUCTIONS
A. Installation Work and Electrical Wiring Must Be Done By
Qualified Person(s) In Accordance With All Applicable
Codes And Standards, Including Fire-Rated Construction.
B. When cutting or drilling into wall or ceiling, do not
damage electrical wiring and other hidden utilities.
C. Ducted fans must always be vented to the out-
doors.
WARNING - TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:
WARNING - TO REDUCE THE RISK OF FIRE, USE ONLY METAL DUCTWORK.
D. Sufficient air is needed for proper combustion and
exhausting of gases through the flue (chimney) of fuel
burning equipment to prevent back drafting. Follow the
heating equipment manufacturers guideline and safety
standards such as those published by the NationaI Fire
Protection Association (NFPA), and the American
Society for Heating, Refrigeration and Air Conditioning
Engineers (ASHRAE), and local code authorities.
Read and Save These Instructions
Turn Page For More Instructions
All Hoods Should Be Installed By A Qualified Installer
Step 1 . . .
Step 3 . . .
Step 2 . . .
Step 5 . . .
Step 4 . . .
Set hood on floor with
wood pallet still attached
to top.
Remove blower deck, light
assembly and transition from
hood.
Run 8 diameter duct and
wiring through ceiling with
section long enough to
reach transition on hood.
Install duct cover to load
bearing framing in
ceiling. For additional
stability in duct covers
over 24 tall, use 1/4 all-
threaded rods.
Attach hood to bottom of duct cover
and re-install blower and light units.
LOAD BEARING FRAMING
(furnished by others)
MOUNTING PLATES ON EACH CORNER
DUCT COVER
4 MOUNTING HOLES
LOCATED IN CORNERS
HOOD
LOAD BEARING FRAMING
CEILING
8 DUCT
TRANSITION
DECK
T200 BLOWER
5 x 16 to 8 DIAMETER
VP546
TRANSITION
FURNISHED
WITH HOOD
