ColdFresh-Value
The temperature in the ColdFresh is set to the value 5
on delivery. The status indicator on the display shows the
appropriate target temperature in the ColdFresh.
You can change this value slightly if a higher or lower
ambient temperature makes it necessary. When setting the
value, note:
Value Description
1
Lowest temperature
1-4
The temperature can drop to below 0 °C, so food
can freeze easily.
5
Default temperature
9
Highest temperature
ColdFresh-Value
Choose the setting
u
Set the size in the Customer menu (see 6.2 Control
FreezerLevel
The FreezerLevel enables the 4-star freezer compartment to
be set to a slightly warmer or colder temperature.
The FreezerLevel is set to 5 by default.
The 4-star freezer compartment becomes colder if the value
is set to less than 6. The 4-star freezer compartment
becomes warmer if the value is set to more than 5.
Selecting the setting value
u
Set value in customer menu (see 6.2 Control concept) .
Reminder for the carbon filter
Reminders are given out acoustically by a beep and visually
by a symbol in the display. The signal gets louder until the
alert stops.
Replacing the carbon filter
This message appears when the air filter needs replacing.
u
Change the air filter every six months.
u
Confirm the message with OK.
w
The service interval resets.
w
The air filter guarantees the air quality in the fridge.
Activating the setting
u
Activating/deactivating (see 6.2 Control concept) .
Reset
This function resets all settings to the factory settings. All
settings that you have made thus far will be reset to their
original values.
Activating the setting
u
Activate (see 6.2 Control concept) .
Turn off appliance
This setting turns off the whole appliance.
Switching off the entire appliance
Fig. 8
u
Activating/deactivating (see 6.2 Control concept) .
w
Off: Display goes black.
6.5 Fault messages
Fault messages appear in the display. There are two catego‐
ries of fault message:
Category Meaning
Message Reminder of general procedures. You can carry
out these procedures to eliminate the message.
Warning Appears when there are malfunctions. A signal
sounds in addition to the display. The signal
becomes louder until you acknowledge by
tapping the display. You can eliminate simple
defects yourself. For more serious defects, you
must contact customer service.
6.5.1 Warnings
Close the door
This message appears if the door is open for too long.
You can set how long it takes for this message to appear .
u
Stop alarm: Confirm the message.
-or-
u
Close the door.
Fault
This message appears if there is a fault with the appliance.
An appliance component indicates a fault.
u
Open the door.
u
Note down the fault code.
u
Confirm the message.
w
The signal tone stops.
w
The status display appears.
u
Close the door.
u
Contact customer service. (see 9.4 Customer Services)
6.5.2 DemoMode
When “Demo” is shown in the display, the demonstration
mode is active. This function is designed for dealers, as all
refrigeration-related functions are deactivated.
Stopping DemoMode
If you see the following running in the display:
u
Confirm the display within the countdown.
w
DemoMode is off.
If the timer is not running:
u
Unplug the appliance.
u
Plug the appliance in again.
w
DemoMode is off.
Controls
* Depending on model and options
71
