V-TUF RUCKVAC, Operator'S Manual

Page: 12 / 12

CLEANING THE SHAKE-OUT BAG WHEN USED WITH THE DUST BAG
1. Remove the Shake-Out Bag, holding the handle at the bottom of the bag, shake
out doors vigorously over a garbage receptacle until there is no more dust.
2. Inspect Shake-Out Bag regularly for tears or damage. Replace Shake-Out Bags if
damage or tears are present.
CLEANING THE SHAKE-OUT BAG WHEN USED ALONE
1. Remove the Shake-Out Bag, empty trash can, and shake vigorously out doors
until there is no more dust.
2. The Shake-Out Bag is hand wash-able in lukewarm water .
3. Allow to air dry for 24 hours . The Shake-Out Bag should be replaced when
needed. Never replace into the vacuum if still wet.
Note. If used often without dust bag, replacement and washing wilbl e
required more often
4. Replace clean Shake-Out Bag in unit ,and r eplace the canister lid.
CLEANING THE HEPA PRE-MOTOR FILTER
Important, Please Note. The HEPA Pre-Motor Filter will stop most of the tiniest
dust particles and airborne allergens from re-entering the air you breathe. In fact
it stops 99.95% of all particles as small as 0.3 microns-many times smaller than a
human hair! Because of this incredible filtration performance, the
HEPA Pre-Motor
Filter will accumulate many fine dust particles that are difficult to see. Be assured that
the
HEPA Pre-Motor Filter is doing the job. Clean the HEPA Pre-Motor Filter after
each use as described in this section.
1. Remove the Shake-Out Bag from the canister. The HEPA Pre-Motor Filter is
located underneath the Shake-Out Bag. To remove the HEPA Pre-Contents into a
motor filter, lift the form the sides of the HEPA filter.
2. Vigorously “Tap Clean” the HEPA Pre-Motor Filter on a hard surface to remove
any residual dust that might still be on the HEPA Pre-Motor Filter.
3. You can wash the HEPA Pre-Motor Filter by running it under the tap and allowing
the water to run on the dirty side at least once a month or when suction appears
to be decreased.
Wash once a month or when suction appears reduced.
WARNING
Allow 24 hours for drying before replacing in unit.
®
V-TUF.COM