12
USING YOUR VACUUM
1. Insert the power plug into the wall outlet.
2. Connect hose and telescopic tube if desired.
3. Correctly place shoulder straps on each shoulder and secur
e the waist band
with hook and loop strips. (Fig.16)
Caution. If the waist band and both shoulder straps are not properly and
securely in place the unit could fall off your back causing damage or injury.
4. Turn the unit on by pressing the switch located near the base of the unit to
turn the vacuum cleaner on. (Fig.17)
REMOVING AND REPLACING HEPA
To remove the Dust Bag from the vacuum:
Important. Do not use the vacuum without all filters, Shake-Out Bag,
and with or without Dust Bag in place.
1. To remove the Dust Bag, press on the canister lid tabs on each side
of the unit and lift canister lid. (Fig.18)
2. Pull the tab on the Dust Bag holder out slightly and lift upwards. (Fig.18)
3. Holding the Dust Bag in your hand, slide it out from the slots in the
bag holder. Hold carefully in order to avoid having dust fall out of
Dust
Bag. (Fig.19)
4. Replace the Dust Bag with a new bag.
Do not
reuse the same bag.
5. The cardboard face of the new bag should rest securely in the dust bag
cover guides.
6. Replace the Shake-Out Bag into the vacuum.
7. To replace the Dust Bag holder, flip the holder and press tab until it clicks.
8. Replace the canister lid onto the vacuum.
Warning. NEVER over fill the Dust Bag – replace when bag is full
and clean the Shake-Out Bag and filter each time the Dust Bag is replaced.
CLEANING & REPLACING THE SHAKE-OUT BAG
Note. Clean the Shake-Out Bag out-doors when changing the DustB ag.
Optimum performance is achieved by using the Dust Bag with the Shake-Out
Bag decreasing the need for washing the Shake-Out Bag.
