TM-50XL Quick Start Guide
D291720.6a
Page 3 of 4
Rev. 1, 6/7/17
7.
Mount the Controller
Using a 5/32” hex wrench, remove the 1/4” BHCS from the top of the
Controller Pedestal
(7a)
.
Attach the
Controller Baseplate
(7b)
to the pedestal using the 1/4” BHCS.
Place the
Controller
(7c)
on the controller baseplate. Engage the four corner holes in the
controller baseplate with the four rubber feet on the bottom of the controller so that it is seated
securely.
8.
Connect Cables
Connect the peripheral cable to the right side of the machine and then to the receptacle labeled
Peripheral
(8a)
on the back of the controller.
Plug the foot switch into the receptacle labeled
Foot Switch
(8b)
on the back of the controller.
Plug the power supply cord into the receptacle labeled
Power
(8c)
on the back of the controller.
Set up
Front View
1.
Power/E-Stop & Take-up Controls
2.
Payout Arm
3.
Cover Tape Arm
4.
Take-up Arm
5.
Sealer Controls
6.
Controller
7.
Sealer Position Adjusters
1.
Power On
Turn the
Power/Emergency Stop Button
(1a)
on the front of the controller to turn the TM-50
on. Ensure the
Take-up Tension Knob
(1b)
is fully counterclockwise in the OFF position.
2.
Set Track Width
The width of the loading track adjusts by moving the front track in and out on two
Detent
Shafts
(2)
. Pull or push the front track until the correct detent is engaged on both sides. If it is
unclear which position is needed, use a sample of the carrier tape that will be loaded and
compare it to the track. Adjust the loading track as necessary if it does not fit.
3.
Load Carrier Tape
Remove the reel lock from the
Payout Reel Spindle
(3a)
by pulling the two disks apart and
sliding it off the spindle. Place a bulk
Carrier Tape Reel
(3b)
on the payout arm
,
positioning it
so the tape unwinds from the top and the sprocket holes are on the inside.
Replace the reel
lock.
1
4
3
1a
1b
3b
3a
2
5
6
7
8a
8b
8c
7a
7b
7c
2
