• Switch off the power
• Remove the cover of the luminaire. (Refer to figure 1)
• Find the wire hole in the bottom and pass the power wire through hole. Connect the power wire into connection-wire
column according to the connection-wire diagram.
• Fix the bottom with inflated screw on the selected position.
• Switch of the power and test it
• Turn the Time knob anti-clockwise on the minimum. Turn the TIME knob clockwise on the maximum (sun).
• Switch on the power; the lamp will have no signal at the beginning. After Warm-up 30sec, the lamp will start to
work. If it recceives the induction siganl, the lamp will turn on. While there is no another induction signal any more,
the lamp should stop working within 10sec+3sec.
• Turn LUX knob anti-clockwise on the minimum (moon). If the ambient light is more than 3LUX, the lamp should not
work. If the ambient light is less than 3LUX (darkness), the sensor would work. Under no induction signal condition,
the lamp should stop working winthin 10sec+3sec.
• Should be installed by qualified electrician.
• Before installing please make sure the power is OFF to avoid electric shock.
• Avoid installing it on uneven surface.
• Avoid pointing the detector towards objects with highly reflective surfaces, such as mirrors etc.
• Avoid mounting the detector near heat sources, such as heating vents, air conditioning units etc.
• Avoid pointing the detector towards objects that may move in the wind, such as curtains, tall plants
NOTE:
When testing in daylight, please turn LUX knob to (SUN) position, otherwise the sensor lamp could not work!
INSTALLATION DIAGRAM
TEST
WIRING DIAGRAM
Figure 1
Figure 2
This marking indicates that this
product should not be disposed of
with other household wastes.
Caution, risk of electric shock.
Summary of Contents for VT-13
Page 4: ......
