V-TAC Merrytec MK054V RC Series, Installation Instruction

Page: 9 / 105

INITIALIZATION
1. On/Off function /3-step dimming function:
After power on, the sensor automatically turns on light at 100% brightness. After 10sec, it
turns off the light. During the initialization, the sensor is not able to detect movement.
2. 2-step dimming function:
After power on, the sensor automatically turns on light at 100% brightness. After 10sec, it
dims the light to a low light level (set by stand-by dim level). During the initialization, the
sensor is not able to detect movement.
FACTORY SETTING
Detection area: 100%, Hold Time: 5S, Stand-by Period: 0s, Stand-by dim level: 10%,
Daylight Sensor: Disable
APPLICATION NOTICE
1) The sensor should be installed by a professional electrician. Please turn off the power
before installing, wiring, changing the setting of the DIP switch.
2) The sensor which installed in the plastic and glass lampshade will reduce the sensitivity.
For every 3mm increase in thickness, the sensitivity will be reduced by 20%.
3) The dimming performance could be different from different 1-10v drivers.
4) The light sensitivity threshold is in a sunny environment, no shadow and ambient light
diffuse reflection. Ambient lux level could be different in different environment, weather,
climate, time-of-day and season.
5) The parameters of the sensor may need to be reconfigured in different installation
environments.
6) This sensor is for indoor use only. It will affect the waterproof effect for outdoor use. Wind,
rain, and moving objects around will cause false triggering.
7) The distance between any inductive sensors should be greater than 3m.
8) Do not place the sensor close to high-density objects such as metal, glass,concrete walls,
etc, false triggering could happen. When the sensor is installed in a metal lamp, metal
reflective surface, or a narrow enclosed environment, the microwave will be reflected
repeatedly and cause false triggering. Please reduce the sensitivity or contact the manufac-
turer for technical support.
9) Please ensure that there are no moving signals around the sensor, such as fan,DC motor,
sewer pipe, air outlet, etc., the sensor may generate false trigger.
10) You are advised to test 5 samples before mass application of sensor in a new lighting
project.
11) Due to continuous improvement, the contents of this instruction could be changed
without prior notice.
8