Exercising Information
Note
In accordance with BS EN 957,
To ensure smooth efficient cycling action, the magnetic braking
system on your Magnetic Cycle Trainer has been correctly
adjusted by our factory during production. To adjust the pedalling
resistance during use, starting by turning the Tension Control Knob
(54) to the position "1" from the begining of your workout.
Gradually increase the pedalling resistance by turning the Tension
Control Knob as required.When you have finished your routine,
turn the Tension Control Knob to the position "8" again to ensure
that the Tension Control Cable is not under tension when your
Magnetic Cycle Trainer not in use.
For security and stability, your Manual Magnetic Cycle Trainer
has a factory welded frame and once fully assembled correctly,
should not need further alignment. However, in the interest of
safety, please always ensure that your Cycle Trainer is positioned
on a solid, flat surface. If necessary, use a rubber mat underneath
to reduce the possibility of damaging flooring or slipping in use.
If you need to make a fine adjustment, simply twist the end of
either Rear Frame Stabiliser End Cap (37) to compensate for
uneven floors.
the braking system on your
Cycle
is speed-independent.
The foot print for this product is
1350mm x 640mm.
Note
1350mm
640mm
GENERAL USER INFORMATION
LEVELLING THE CROSS TRAINER
RESISTANCE ADJUSTMENT
54
37
Page 12
