23
4) Read the measured resistance value from the LCD.
Note
：
1) The measured resistance on the circuit will usually
differ from the resistance rating.
2) In the measurement of low resistance, in order to
measure accurately, please short-circuit the two test leads,
read out the resistance of the test leads short-circuit, after
measuring the resistance to be measured to be subtracted
from the resistance.
3) At 60M
Ω
, the meter may take a few seconds to
stabilize the reading, which is normal for high resistance
measurements.
4) When the meter is open, the display will show "0L",
indicating that the measured value is out of range.
4.10 Diode Test
Warning
Risk of electric shock.
To avoid damage to the meter or the device
under test, all power to the circuit under test
should be cut off and all high voltage capacitors
fully discharged before measuring the resistance.
Test a diode outside the circuit
1) Turn the rotary switch to the gear, press “
SEL
”
button to switch to
test status.
2) Insert the black test lead into the
COM
jack, and the
red test lead into the Jack.
3) Connect the other end of the red test lead to the diode
anode and the other end of the black test lead to the diode
cathode for testing.
