5.2.1
How To Clear Tare Function (auto tare, manual tare, preset tare)
a.
To clear auto tare, remove the initial weight/load from the platter and
NET
indicator will turn off.
Press
ZERO
key to return to zero weight status if
ZERO
indicator does not appear.
b.
To clear manual tare, remove everything from platter and press
TARE
key, the
NET
indicator will
turn off. Press
ZERO
key to return to zero weight status if
ZERO
indicator does not appear.
c.
To clear preset tare, press 0 on the numeric keypad first and then press
TARE
key to cancel
preset tare. Please make sure scale is not engaged in any kind of tare before proceed to modify
the pre-tare value.
NOTE:
It is regulated by OIML R76 that in dual range application, tare value will be cancelled automatically
when returning from W2 to W1.
5.3
HOW TO USE THE COUNT FUNCTION
The result of total piece count is the result of calculation from weight being placed on the platter
against with unit piece weight. There are two methods to obtain the unit weight:
5.3.1
Automatic Sampling
a.
Refer to the above steps about how to weigh and place a known quantity on platter
b.
Use numeric keypad to enter the known quantity and press
QTY SET
c.
Scale will show the piece weight in
UNIT WEIGHT
window
5.3.2
Direct Entry
a.
Refer to the above steps about how to weigh and place a load on platter
b.
Use numeric keypad to enter the piece weight and press
WT. SET
c.
The total quantity will be in
TOTAL COUNT
window
d.
To set another piece weight, remove the load and manually enter the unit piece weight and
press
WT. SET
e.
If a mistake a found when key in the value, press
CL
to start again. To cancel the unit weight,
press 0 and then press
WT.SET
5.4
HOW TO USE MEMORY FUNCTION
5.4.1 To Save To Memory
This scale comes with memory function and result can be transmitted through optional RS232
interface.
a.
Obtain the total count by either automatic sampling or direct entry
b.
Press
M+
Summary of Contents for VOC Series
Page 1: ......