c. Press
SAMPLE SET
four times
d. Scale displays
F.5
e. Press
MODE
to select baud rate of 4800, 9600 and
19200
f. Press and hold
MODE
for 2 seconds to enter
transmission protocol setup
g. Press
MODE
to select protocol of N81 or E71
h. When the preferred transmission protocol shows on
display, press
ON/RE-ZERO
to confirm and restart
the scale or
SAMPLE SET
for next function setup
NOTE:
The default data output format of the scale is
Baud Rate = 9600
Data Bit = 8
Stop Bit = 1
Parity = None
4.2.4 Select Data Transmission Mode
This scale provides 2 types of transmission mode
depending on the requirement and environment.
a. Scale is off
b. Press and hold
SAMPLE SET
, then press
ON/RE-ZERO
c. Scale displays
F.1
d. Press
SAMPLE SET
five times
e. Scale displays
F.7
f. Press
MODE
to select transmission mode ¡§trAn1¡¨ o
¡§trAn2
g. When the preferred data transmission mode shows on
display, press
ON/RE-ZERO
to confirm and restart
the scale or
SAMPLE SET
for next function setup
NOTE:
¡
trAn1
¡¨ is to transmit data continuously after reading
is stabled
¡
trAn2
¡¨ is to transmit single data only after reading
is stabled. However, scale will not send any data if
weight detected is less than the minimum load.
4.2.5 Select Auto Tare Function
This scale is equipped with auto tare function which
tares off the initial weight automatically when this
function is engaged. The tare weight is automatically
cleared when everything is removed from platter.
a. Scale is off
b. Press and hold
SAMPLE SET
, then press
ON/RE-ZERO
c. Scale displays
F.1
d. Press
SAMPLE SET
six times
