UV Pure Technologies Hallett 30, Instruction Manual, Page: 7 / 40

Hallett 30 1” Instruction Manual
Released on 1-Sep-16
– X800058R
Page 7 UV Pure Technologies Inc. © 2016
WARNING: Potential Shock Hazard
Use only a grounded electrical outlet when connecting the unit to a
power source. If an extension cord is necessary, the cord should
contain a ground and be rated for the same amperage as the unit or
combined units. Do not plug in unit if water is present on the unit.
WARNING: Ultraviolet Light Hazard.
The lamps in the unit emit ultraviolet (UV) light that can cause
permanent damage to the skin & eyes.
Never look at the lamp when
it is operating. Do not plug the unit in unless it is properly secured to
a wall (see Installation Instructions) and all the covers are installed. Do
not remove any cover unless the unit has been unplugged. Never look
into the unit or place any exposed skin into the illuminated areas when
it is operating. Do not operate a unit that has been damaged or missing
any components or safety devices.
The Hallett unit is not intended for use by young children or infirm
persons without supervision. Young children should be supervised to
ensure that they do not play with the Hallett unit.
Parts Included

Hallett UV system complete with integral wall brackets (1)

Ultraviolet lamps (2)
– installed within the unit

Instruction manual (1)

Power cord (1) (located within packaging)

Stainless flexible hoses (2) per system, for bottom inlet & top outlet

External alarm contact for remote monitoring.

Transient Voltage Surge Suppressor (TVSS)/Surge Protective Device
(SPD) for North American markets (120Vac systems)

Pipe wrap insulation for top hose

Cold Air Kit complete with installation instructions for Hallett 30 units (If
not immediately used, keep in a safe place.
Do not discard these
items )
Optional
– Automatic shutoff solenoid valve
Pre-treatment sediment and or carbon filter to remove water
particles, odour or trace chemicals for improved taste.
Other Materials Needed
The Hallett requires
1” male NPT fittings for the hose connections and also the
solenoid valve. These fittings and any piping compatible with the plumbing
should be on hand before you begin installation. See Figure 1B and make a list
of all necessary components including solder, paste and thread sealant. Bypass
piping and valves that isolate the unit are optional, as is a drain valve for
draining the unit.
Pipe insulation is provided to wrap around the top hose coming out from
the unit. Any other piping overhead must also be wrapped to prevent
UV UV UV