Hallett
30 1” Instruction Manual
Released on 1-Sep-16
– X800058R
Page 24
UV Pure Technologies Inc. © 2016
This will close the solenoid valve and temporarily shut off the water supply.
Caution:
The lamps heat up after continuous use and can burn your skin if
touched. Allow lamps to cool for five minutes before removing them.
Step 2:
Remove the top cover and bottom covers by removing the screws.
Step 3:
Slowly lift the old lamps out of the unit.
Do not twist the lamps when
they are installed.
For assistance in this task, use a flat screwdriver and pry the
lamps between their base and the socket to disengage the pins (see Figure 3).
Dispose of the old lamps in the same way as you would dispose of ordinary
fluorescent tubes. Note that old lamps should be disposed of at a household
waste management depot or transfer station; contact your local recycling and
waste management authority for proper disposal procedures in your area.
If one or both lamps exhibit significant discoloration at their ends, this
implies the lamps and ballast have expired. Both lamps and ballast must
be replaced. Operating new lamps with an expired ballast will cause
damage to the new lamps.
Step 4:
Install the new lamps into the unit, being careful not to touch the bulb.
Ensure that the lamps are aligned with the “Stop Sign” printed on the top
ceramic facing inward (towards quartz sleeve). If you can see the stop
sign, the lamps are backward (See Figure 3).
WHILE PINS ARE ENGAGED
DO NOT TWIST / TURN THE LAMPS
BOTTOM VIEW
UV
www.uvpure.com
FACES OUT
FACES IN
Figure 3
Once the pins of the lamp begin to engage into the lamp socket, push firmly
down on the top of the lamp.
Do not twist the lamps when they are inserted.
